发电机不发电可能由多种原因造成，以下是一些常见的原因及其简要说明：

　　The failure of a generator to generate electricity may be caused by various reasons. The following are some common reasons and their brief explanations:

　　剩磁问题 ：

　　Residual magnetism issue:

　　新装的发电机在长途运输或长时间静置后，铁芯剩磁可能异常。

　　The residual magnetism of the iron core of a newly installed generator may be abnormal after long-distance transportation or prolonged standing.

　　剩磁电压低于正常值（线电压低于10痴，相电压小于6痴）可能导致发电机无法正常发电。

　　The residual voltage below the normal value (line voltage below 10V, phase voltage below 6V) may cause the generator to fail to generate electricity normally.

　　电路错误 ：

　　Circuit error:

　　励磁绕组极性反转或误操作导致电阻测量错误，可能造成剩磁消失。

　　The polarity reversal or misoperation of the excitation winding may cause measurement errors in resistance, which may result in the disappearance of residual magnetism.

　　电路堵塞与连接问题，如励磁电路中的接触不良或电线松动断裂，可能导致电流中断。

　　Circuit blockage and connection issues, such as poor contact or loose or broken wires in the excitation circuit, may cause current interruption.

　　旋转整流器问题 ：

　　Rotating rectifier issue:

　　如果旋转整流器的直流侧电路出现故障，交流励磁机无法提供励磁电流。

　　If the DC side circuit of the rotating rectifier malfunctions, the AC exciter cannot provide excitation current.

　　发电机过热 ：

　　Generator overheating:

　　过热可能由多种原因引起，如负载过大、冷却系统故障等。

　　Overheating may be caused by various reasons, such as excessive load, cooling system failure, etc.

　　励磁回路接线错误 ：

　　Excitation circuit wiring error:

　　励磁绕组的极性接反或在测量励磁绕组的顿颁电阻时未注意极性，可能导致剩磁消失。

　　Reversing the polarity of the excitation winding or not paying attention to the polarity when measuring the DC resistance of the excitation winding may result in the disappearance of residual magnetism.

　　励磁回路电路不通 ：

　　The excitation circuit is not connected:

　　电气接触不良、接线头松脱或引线断裂，造成电路中断。

　　Poor electrical contact, loose connectors, or broken leads can cause circuit interruption.

　　旋转整流器DC侧的电路中断 ：

　　Circuit interruption on the DC side of the rotating rectifier:

　　旋转整流器直流侧电路中断，导致交流励磁机无法提供励磁电流。

　　The DC side circuit of the rotating rectifier is interrupted, causing the AC exciter to be unable to provide excitation current.

　　发电机皮带打滑 ：

　　Generator belt slippage:

　　皮带打滑会导致发电机无法将动力传递给发动机，进而无法发电。

　　Belt slippage can cause the generator to be unable to transmit power to the engine, resulting in the inability to generate electricity.

　　发电机励磁绕组故障 ：

　　Generator excitation winding fault:

　　励磁绕组损坏或故障可能导致发电机无法产生足够的磁场。

　　Damage or malfunction of the excitation winding may result in the generator being unable to generate sufficient magnetic field.

　　电压调节器故障 ：

　　Voltage regulator malfunction:

　　电压调节器故障可能导致发电机输出电压不稳定或不正确。

　　Voltage regulator malfunction may cause unstable or incorrect output voltage of the generator.

　　电瓶损坏 ：

　　Battery damage:

　　电瓶无法提供足够的启动电源或充电，影响发电机的正常启动和运行。

　　The battery cannot provide sufficient starting power or charging, which affects the normal starting and operation of the generator.

　　定子绕组绝缘击穿或短路 ：

　　Insulation breakdown or short circuit of stator winding:

　　定子绕组绝缘损坏或发生短路，会导致电流无法通过，发电机无法发电。

　　The insulation damage or short circuit of the stator winding can cause the current to be unable to pass through, and the generator cannot generate electricity.

　　定子铁芯松驰 ：

　　Loosening of stator core:

　　定子铁芯松驰可能影响发电机的磁通，进而影响发电效率。

　　The looseness of the stator core may affect the magnetic flux of the generator, thereby affecting the power generation efficiency.

　　三相负载不平衡 ：

　　Unbalanced three-phase load:

　　叁相负载不平衡可能导致某一相过热，影响发电机的正常运行。

　　Unbalanced three-phase loads may cause one phase to overheat, affecting the normal operation of the generator.

　　功率不足 ：

　　Insufficient power:

　　如果发电机的功率不足以满足负载需求，可能无法正常发电。

　　If the power of the generator is not sufficient to meet the load demand, it may not be able to generate electricity normally.

　　以上列出的原因并非详尽无遗，实际情况可能因具体设备和使用环境的不同而有所差异。如果发电机出现不发电的情况，建议联系专业的维修人员进行检查和维修

　　The reasons listed above are not exhaustive, and the actual situation may vary depending on the specific equipment and usage environment. If the generator fails to generate electricity, it is recommended to contact professional maintenance personnel for inspection and repair

　　本文由焦化发电机组提供帮助，更多的相关内容请点击：希望本文能够为您带来帮助，感谢您的阅读！

　　This article is assisted by coking power generation units. For more related content, please click: I hope this article can be helpful to you. Thank you for reading!